Buildbotics Forum

OK great! Thanks for the update.

I'll turn one on and let it sit till tomorrow to see if mine gets slow too.

If you just let it sit idle, how long does it take to get slow?

Hmmm, Here's a few questions: What vertion of software are you running? Are you accessing the controller from a local monitor or across a network? If across a network, what browser are you using? Does it get slow even when you are not running program? If it only gets slow when running a program, how...

Version 2.0.3 has been released. It improves the ability of the controller to withstand incorrect motor wiring.

There hasn't really been a need until now. I applied the changes that you recommended yesterday.

If the limit switch is active when you start the homing procedure, the axis will start out in the wrong direction because it thinks it has ready found the switch and starts the back-off step. This can happen if the switches are configured to be normally open but they are wired for normally closed, o...

Just open the manual up in your web browser and the use your browser print function to print to a pdf file. Then print the file.

Yes, the controllers that we have been shipping for the past couple of years all have the 0-10 volt analog output.

Thanks for the contribution. Did you mean M4 and M5? G4 is the dwell command and G5 is not supported on the BB Controller. In addition, laser users should be aware of two nice features: * 'rapid-auto-off' - When enabled, the laser is automatically turned off during rapid moves. This prevents lines b...