Buildbotics Forum

Did give that a try via /boot/config.txt and either it didn't do anything (couldn't really tell if it was scaled up to fill screen, eyes aren't as sharp as they used to be!) or it worked fine, but didn't affect the touch calibration. Thanks for the suggestions. Was excited to finally have a touch in...

No, running in its 1080p native resolution in portrait mode. The touchscreen calibration problem exists exactly the same regardless of orientation, it's off in the same direction relative to the monitor itself (left/right in landscape, now up/down in portrait). Don't know how to change frequency (sp...

I realize this is very old, replying mostly so that this info is recorded somewhere. But here's what you needed to do: Run the following, ignore inside the brackets: sudo mount -o remount,rw /boot [makes the file system writable] sudo nano /boot/config.txt [edit the config file] add: display_rotate=...

Have a controller running 1.0.3. Picked up an Elo ET2201 touchscreen. Plugged in and is completely functional right away, except the horizontal calibration is off on the touchscreen. In the center, it's on. But as you touch further outward, it gets more and more off. When you touch the outer LH/RH e...

This should still be addressed, but just in case anyone else has this same issue after changing monitors, I fixed it and here's how. I found that config.txt was specifying the screen resolution. Normally on a Pi this is not declared, but there must be something in the BB firmware that does it upon f...

When I first started using my BB controller, I had it plugged into a widescreen monitor via HDMI of course. I recently switched it to a standard old 19" LCD, but the video output remains in widescreen. Restarted, dug through settings. Seems like a silly problem but I can't figure out how to fix it, ...

My hope is to solve these "special' functions with programmable buttons. The idea is that users could write a g-code sequence that is automatically executed when a programmable button is clicked. You can follow the status of our implementation of programmable buttons on github at https://github.com...

A few things that at this moment in my limited experience I'd like to see. I have been pouring over CNC router how tos, forums, and have enough experience on my current machine I am starting to get a feel for what to incorporate in the next one. Also, disclaimer, I might be doing something fundament...

Pulled from github this morning about 10am. Vcarve was installed about a week ago. I tried Buildbotics_inch.pp, _mm, _no_jet_inch and _no_jet_mm. Error happens like this (in Vcarve Desktop V10 Trial): Toolpaths -> Install Post Processor... Select Buildbotics_inch.pp Error dialog box pops up with the...

Trying to install a PP with Vcarve desktop (just downloaded, V10). Didn't see a buildbotics PP included anywhere, and when I tried to install any of the ones you listed it fails.

"Config file
Unknown statement in file
On line 7 of file
....\Buildbotics_inch.pp"