Here is a pic of my new DIY CNC machine! So far I’ve just used a pen to draw the Buildbotics logo and another gcode file. Hope to be cutting some test cuts with it this weekend. Thanks to Doug and Joe for all the support with the controller!
Mark
Search found 3 matches
- Thu Mar 04, 2021 4:39 pm
- Forum: User Developments
- Topic: New DIY CNC
- Replies: 1
- Views: 12412
- Wed Mar 03, 2021 3:19 pm
- Forum: Buildbotics Tech Support
- Topic: Firmware development on Debian 10.8
- Replies: 1
- Views: 2901
Firmware development on Debian 10.8
Hi,
I was reading through the docs on GitHub about the firmware. The development.md says to use Debian 9.6, which is not the latest release. Is development on the latest Debian release 10.8 supported?
Thanks!
I was reading through the docs on GitHub about the firmware. The development.md says to use Debian 9.6, which is not the latest release. Is development on the latest Debian release 10.8 supported?
Thanks!
- Wed Mar 03, 2021 3:17 pm
- Forum: Buildbotics Tech Support
- Topic: Unable to set soft limit to a negative number.
- Replies: 7
- Views: 9387
Re: Unable to set soft limit to a negative number.
Hey, I know this is an old post, but I’m experiencing the same issue. What’s happening is when you try to set a negative minimum soft limit on an axis from the controller itself you’ll get the error message about parsing the float. If you do the same thing connected remotely, the issue doesn’t occur...