Buildbotics Forum

I am thinking that I may do a Lowrider CNC kit from V1, any known issues, any development or experience with this controller for that app?

When you say configured, do you mean hardware (switches, disconnecting etc) or software configuration?
If software, I would assume some code is in the front end of the g code program that sets this. Is this the case?

Is the OP doing better? Increasing RPM and decreasing feed rate in the arc may help too, if the speed to feed ratio is too low.

I've thought about it more and refined the question. In order to leave both devices connected to the controller, while using one or the other, I would need to have a separate on/off commands for each head. If M03 is Spindle cw, M04 is spindle ccw and M05 is spindle off, I would need another pair of ...

Not a router owner yet, in planning stages. I have a background in Machining/sheet metal Mfg Eng though. I think you have a pretty good product, but I would like to understand how I might use it wire up both a VFD spindle control such that I can control speed in the parts program, but also run a las...