Search found 3 matches
- Sat Jun 11, 2022 8:09 am
- Forum: Buildbotics Tech Support
- Topic: G20 vs G21 Sizing of Test Cut
- Replies: 1
- Views: 10918
G20 vs G21 Sizing of Test Cut
In Carbide Create, I'm using inches. I create a test file that fits within an 18" square. I then export it and the gcode has a G21. When I do the 3D preview, it's the correct size. When I run the program, it goes to mm and runs off the end of the table. When I change the G21 to G20, the 3D preview i...
- Fri Jun 10, 2022 8:34 pm
- Forum: Buildbotics Tech Support
- Topic: Pause/Resume Estop
- Replies: 1
- Views: 10844
Pause/Resume Estop
In 4.2.3 Status Table, it mentions holding by pausing a program. Is there a way to wire a pause/resume into the Estop via the 25 pin I/O port?
- Sun May 15, 2022 2:00 pm
- Forum: Buildbotics Tech Support
- Topic: Slaved Motor Switching Directions
- Replies: 1
- Views: 10227
Slaved Motor Switching Directions
I have M1 set to X axis and M2 set to X axis (slave). When I use the game controller, the gantry initially goes in the correct direction, but then subsequent jogs cause the motors to go in opposite directions, torqueing the gantry. I have tried every combination of which motor is the slave, reversed...