Buildbotics Forum

In Carbide Create, I'm using inches. I create a test file that fits within an 18" square. I then export it and the gcode has a G21. When I do the 3D preview, it's the correct size. When I run the program, it goes to mm and runs off the end of the table. When I change the G21 to G20, the 3D preview i...

In 4.2.3 Status Table, it mentions holding by pausing a program. Is there a way to wire a pause/resume into the Estop via the 25 pin I/O port?

I have M1 set to X axis and M2 set to X axis (slave). When I use the game controller, the gantry initially goes in the correct direction, but then subsequent jogs cause the motors to go in opposite directions, torqueing the gantry. I have tried every combination of which motor is the slave, reversed...