Vectric Post Processor

Exchange information regarding Buildbotics post processors for CAD/CAM programs.
Post Reply
User avatar
Doug
Posts: 52
Joined: Fri Feb 02, 2018 4:56 pm

Vectric Post Processor

Post by Doug » Wed Oct 16, 2019 12:09 pm

Vectric has created a Post Processor for the Buildbotics Controller. It will be included in future releases of their products. For existing and older Vectric products, you can get it from github at https://github.com/buildbotics/buildbot ... -processor .

Please report your experiences with this post processor in this forum.

Mick
Posts: 4
Joined: Sun Sep 01, 2019 2:16 am

Re: Vectric Post Processor

Post by Mick » Wed Oct 16, 2019 7:14 pm

That link goes to fusion 360.

Vetric Link
https://github.com/buildbotics/buildbot ... -processor

User avatar
Doug
Posts: 52
Joined: Fri Feb 02, 2018 4:56 pm

Re: Vectric Post Processor

Post by Doug » Thu Oct 17, 2019 9:18 am

Thanks for pointing this out, Mick. The correct link is:

https://github.com/buildbotics/buildbot ... -processor

I also corrected the first posting that you responded to.

User avatar
Doug
Posts: 52
Joined: Fri Feb 02, 2018 4:56 pm

Re: Vectric Post Processor

Post by Doug » Mon Nov 18, 2019 4:51 pm

It seems that my post processors are not fully compatible with older versions of Vectric software. They fail on stuff related to water jet control. So, I created two new posts called buildbotics_no_jet_inch.pp and buildbotics_no_jet_mm.pp . They are now available on github at https://github.com/buildbotics/buildbot ... -processor .

If you have problems loading buildbotics_mm.pp or buildbotics_inch.pp, you should give these a try.

Post Reply