How do I get Manual NC commands from Fusion into Buildbotics?
Posted: Thu Dec 16, 2021 12:59 pm
Hi,
I am trying to use the Manual NC command option in Fusion360, but nothing shows up in the NC code when I post.
This is my setup, with a manual command.
(The manual command is a prompt to remind me to fixture into the holes before cutting the outer contour.)
However, nothing shows up in the output NC code.
I assume something needs to be added to the Buildbotics.cps file, but what? and where?
I am trying to use the Manual NC command option in Fusion360, but nothing shows up in the NC code when I post.
This is my setup, with a manual command.
(The manual command is a prompt to remind me to fixture into the holes before cutting the outer contour.)
However, nothing shows up in the output NC code.
I assume something needs to be added to the Buildbotics.cps file, but what? and where?