The following improvements are incorporated in this new release:
- The EM60 VFD now brakes to a stop rather than coasts to a stop. This causes the spindle to stop much faster.
- Support for the M66 command improved and now provides the ability to pause execution until an i/o input changes.
- All origins and Cross Origin Resource Sharing (CORS) are now configurable on the SETTINGS->Network page. Unless you are doing applications development, using the Buildbotics Controller, you should leave this setting blank.
- Support for the G38.2-5 commands has improved. The command now allow the program to stop if contact is made unexpectedly during a probing command. Check out this thread for more details on how this can be used.
- An improvement was made to the power firmware that prevents damage to the controller that could occur if the 5V power supply becomes overloaded. Overloading of the 5V supply can occur if there are too many devices on the USB connectors or if too much current is drawn from the I/O pins on the DB25 and DB15 connectors.