0.4.14 release

Announcements of general interest
Forum rules
No profanity, No gambling. No porn. No illegal activity of any kind. Violators will be removed without notice.
Post Reply
User avatar
Doug
Posts: 343
Joined: Fri Feb 02, 2018 4:56 pm

0.4.14 release

Post by Doug » Thu Apr 16, 2020 10:02 am

Version 0.4.14 software has been released. It includes the following improvements:
1. The "Jogging" interface found under the "Jog" tab on the "Control" page now works correctly with touch panel screens. Previously, it did not recognized touch and hold gestures from a touch screen. This has been fixed.
2. A "Step mode" check box has been added to the same jogging screen. This allows users to click and hold for continuous motion if 'Step mode' is not checked and to move in predefined increments if 'Step mode" is checked.
3. A user pointed out that attempting to load gcode files with '#' or '?' characters in the file name resulted in unusable files being loaded and those files could not be removed. This problem has been fixed. (Thanks Mick!)
4. Modbus control for V70 Series VFD's has been added to the Buildbotics Controller. V70 Series VFD's are now available StepperOnline at https://www.omc-stepperonline.com/varia ... ncy-drive/ . This interface is configured by selecting "V70" from the pull-down menu on the tool page.

You can upgrade to 0.4.14 for free by clicking the "Upgrade" button on the "General" page and entering your password. The default password it 'buildbotics'.

Post Reply