I am trying to think of ways to integrate THC with the plasma table and the Buildbotics controller. Came across this just a few minutes ago. I briefly read into it, but the height it determined by the voltage....
https://www.vitalsystem.com/portal/cnc/ ... M8QAvD_BwE
Plasma Torch Height Control (THC)
Forum rules
Use of profanity is prohibited.
Gambling is prohibited.
Sexual or pornographic material is prohibited.
Illegal activities of any kind are prohibited.
The moderator reserves the right to deny or delete any content without notice.
Use of profanity is prohibited.
Gambling is prohibited.
Sexual or pornographic material is prohibited.
Illegal activities of any kind are prohibited.
The moderator reserves the right to deny or delete any content without notice.