Plasma Torch Height Control (THC)

This forum is dedicated to retrofitting existing CNC Machines with Buildbotics Controllers.
Forum rules
Use of profanity is prohibited.
Gambling is prohibited.
Sexual or pornographic material is prohibited.
Illegal activities of any kind are prohibited.
The moderator reserves the right to deny or delete any content without notice.
Post Reply
JAtchley
Posts: 9
Joined: Tue Mar 01, 2022 6:50 am

Plasma Torch Height Control (THC)

Post by JAtchley » Tue Apr 26, 2022 4:18 am

I am trying to think of ways to integrate THC with the plasma table and the Buildbotics controller. Came across this just a few minutes ago. I briefly read into it, but the height it determined by the voltage....

https://www.vitalsystem.com/portal/cnc/ ... M8QAvD_BwE

Post Reply