Hi everyone! My name is Mike, and I’ve owned a Lumenlab M3 for a little over 11 years. It’s something I use just a few times a year, mainly cutting 2D control panels and simple things. I’m still using an 11 year old version of EMC2, and a desktop that’s just as old, running Ubuntu. The control side has always been super flaky, and I’ve been wanting to upgrade my setup for a long time. I drive the motors with a cheap TB6560 based board that I had to replace after 7 years with a new one.
I’m curious if there are any other Lumenlab owners using the Buildbotics? I assume they’re compatible, but want to make sure before ordering. The Lumenlab is a 3 axis mill with 4 motors. It has limit switches, but only on one side of each axis.
Thanks very much!
Mike
Lumenlab CNC
Forum rules
Use of profanity is prohibited.
Gambling is prohibited.
Sexual or pornographic material is prohibited.
Illegal activities of any kind are prohibited.
The moderator reserves the right to deny or delete any content without notice.
Use of profanity is prohibited.
Gambling is prohibited.
Sexual or pornographic material is prohibited.
Illegal activities of any kind are prohibited.
The moderator reserves the right to deny or delete any content without notice.