Working on a Dyna 2200
Posted: Sun Oct 24, 2021 7:06 pm
I have been given a Dyna 2200 (doesn't appear to be a Dyna Myte) CNC mill for free and am looking to retrofit another contoller on it and am looking for some information.
As much as I'd like to try a buildbotics controller for this, it is a bit out of my price range at the moment and am looking to use a cheaper controller. My questions though stem from your video where you retrofitted a Dyna Myte 2400 which I understand to be a step above the 2200. My first question is, is there a way to reuse the original stepper drivers that are in the control box?
If not, how hard is it to conect to the steppers using something like a pololu driver, and what would be the steps per mm for these?
Any information you an give to assist in this build is greatly appreciated.
As much as I'd like to try a buildbotics controller for this, it is a bit out of my price range at the moment and am looking to use a cheaper controller. My questions though stem from your video where you retrofitted a Dyna Myte 2400 which I understand to be a step above the 2200. My first question is, is there a way to reuse the original stepper drivers that are in the control box?
If not, how hard is it to conect to the steppers using something like a pololu driver, and what would be the steps per mm for these?
Any information you an give to assist in this build is greatly appreciated.