L1/L2 controll through G-Code
Posted: Sun Feb 03, 2019 12:37 pm
Hi,
the controller manual includes the following sequence:
"The L1 and L2 outputs can be software controlled through G-Code commands or they can be controlled through hardware by applying logic signals to the “Load 1” o r “Load 2” pins on the DB25 I/O connector."
How can i control L1/L2 through G-Code - what commands?
Greetings
Martin
the controller manual includes the following sequence:
"The L1 and L2 outputs can be software controlled through G-Code commands or they can be controlled through hardware by applying logic signals to the “Load 1” o r “Load 2” pins on the DB25 I/O connector."
How can i control L1/L2 through G-Code - what commands?
Greetings
Martin