! Under Override?
Posted: Thu Dec 12, 2019 6:56 pm
Hi Doug,
How do I override the "! under" warning that is preventing me from running my file?
I need to be able to go under to cut all the way through into a spoil board. In another case, I have a tool that needs to use its own weight to make a mark, so it needs to go below Z0.
I don't understand why this "safety" measure installed. It is common to go under Z0 when doing contour cuts through plywood or other materials.
Thanks,
Jason
How do I override the "! under" warning that is preventing me from running my file?
I need to be able to go under to cut all the way through into a spoil board. In another case, I have a tool that needs to use its own weight to make a mark, so it needs to go below Z0.
I don't understand why this "safety" measure installed. It is common to go under Z0 when doing contour cuts through plywood or other materials.
Thanks,
Jason