Load1 36v down to 12v
Posted: Tue May 19, 2020 7:23 pm
So I'm upgrading to a 2.2kw water cooled spindle and was thinking of using the load1 output to turn on and off the water pump.
My controller is currently powered by a 36volt power supply
The water pump is 12volt
My thoughts were to run the load1 output to a step down converter as below
https://au.mouser.com/ProductDetail/MEA ... ejlw%3D%3D
Then from the step down 12 volt to the water pump
Will this work?
Any better solutions?
Thanks
Mick
My controller is currently powered by a 36volt power supply
The water pump is 12volt
My thoughts were to run the load1 output to a step down converter as below
https://au.mouser.com/ProductDetail/MEA ... ejlw%3D%3D
Then from the step down 12 volt to the water pump
Will this work?
Any better solutions?
Thanks
Mick