I need a help to undestand how setup the limit switch.
which limit switch i can use? how I connect with the DB25 I/O port
May i have some example of products and cable setup.
carlo
Limit Switch help
Forum rules
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
Re: Limit Switch help
The most basic type of switch is a lever arm, micro limithttps://www.amazon.com/HiLetgo-V-156-1C ... 467011_1_7. Most of these come with 3 wire points labeled NO [normally open], NC [normally closed], and COM [common]. Run a wire from the COM post to one of the ground terminals on your DB25 breakout board [pins 7,19, or 25]. Run another wire from either the NO or NC post to the correct axis terminal and designate the setting on the control screen.
For example; Motor 0 is your X axis, and it homes to the minimum travel location. The switch is wired from COM to pin 7 and NO to pin 3 on the breakout board. On the buildbotics control screen under Motor 0 in the limits section, min-soft-limit is set to 0, max-soft-limit is set to your specific travel extent, min-switch is set to normally open, and max-switch to disabled.
Doug from buildbotics also has a link to some magnetic proximity sensors that he uses in a post in the FAQ section of this forum.
Currently I'm using Xtension limit switch kits from OpenBuildshttps://openbuildspartstore.com/xtensio ... witch-kit/. These are labeled GND, V+, SIG. My X switch is wired GND to pin 7 and SIG to pin 3 [the V+ wire isn't needed here].
There is other info in the "Docs" section at buildbotics.com [url]https://buildbotics.com/docs/[/url ]if you want to use a 5v proximity sensor.
I hope this helps you some.
MC
For example; Motor 0 is your X axis, and it homes to the minimum travel location. The switch is wired from COM to pin 7 and NO to pin 3 on the breakout board. On the buildbotics control screen under Motor 0 in the limits section, min-soft-limit is set to 0, max-soft-limit is set to your specific travel extent, min-switch is set to normally open, and max-switch to disabled.
Doug from buildbotics also has a link to some magnetic proximity sensors that he uses in a post in the FAQ section of this forum.
Currently I'm using Xtension limit switch kits from OpenBuildshttps://openbuildspartstore.com/xtensio ... witch-kit/. These are labeled GND, V+, SIG. My X switch is wired GND to pin 7 and SIG to pin 3 [the V+ wire isn't needed here].
There is other info in the "Docs" section at buildbotics.com [url]https://buildbotics.com/docs/[/url ]if you want to use a 5v proximity sensor.
I hope this helps you some.
MC