3 point homimg

Post technical questions about the Buildbotic Controller here.
Forum rules
No profanity, no gambling, no illegal activity, so sexual or pornographic material.

Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
Post Reply
JNewcomb
Posts: 5
Joined: Fri Jan 29, 2021 7:41 am

3 point homimg

Post by JNewcomb » Fri Mar 12, 2021 9:05 am

Doug, awhile back you posted your g-code for using a three point touch plate. After a bit of a struggle, I managed to get it working on my machine. I then converted to imperial units and again got it working with my Bill Griggs Makers Guide Triple Edge Finder.
It would be nice if you could add line by line comments to your G-code to make life easier for us budding CNC enthusiast. It took me several attempts to get things just right. With the new firmware, sounds like I will need to break the G-code up for Z axis and XYZ probing. I started to use separate configuration files, but it can be a bit awkward.
Thanks,

User avatar
Doug
Posts: 239
Joined: Fri Feb 02, 2018 4:56 pm

Re: 3 point homimg

Post by Doug » Sat Mar 13, 2021 9:17 am

I have commented the program I sent to you and attached it.
Attachments
find_workpiece.gc
(1.42 KiB) Downloaded 59 times

JNewcomb
Posts: 5
Joined: Fri Jan 29, 2021 7:41 am

Re: 3 point homimg

Post by JNewcomb » Sun Mar 14, 2021 8:26 am

Thanks Doug, I am sure it will help me understand as well as others.

Post Reply