Page 1 of 1

Onefinity CNC controller parity

Posted: Fri Jun 11, 2021 9:19 pm
by 82amp
Hi BB & users,

My understanding is that the OneFinity CNC controller is built upon the BB project. I am not sure how many changes have been made in the hardware, but there are definitely numerous changes to the firmware/software.

Are there any plans to bring the BuildBotics firm/software to feature parity with the OneFinity controller? Does the OneFinity project provide any input back to the BuildBotics project?

There are some features from 1F that I would like to see in the BB controller. My BB controller only arrived yesterday, so I have not had a full chance to dig around it too much, however I did submit a PR to the git hub repository. Not sure if that's something that is welcomed or not?

As a side note- thank you very much for the prompt order and shipping! Ordered in the evening on 8th June, arrived in Australia in the morning on 11th June!

Re: Onefinity CNC controller parity

Posted: Sat Jun 12, 2021 10:55 am
by Doug
We have your pull request and will review it.....thanks