Gcode not being updated after a save

Post technical questions about the Buildbotic Controller here.
Forum rules
No profanity, no gambling, no illegal activity, so sexual or pornographic material.

Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
Post Reply
rtkracht
Posts: 10
Joined: Tue Mar 23, 2021 2:36 pm

Gcode not being updated after a save

Post by rtkracht » Wed Jun 16, 2021 6:07 pm

I'm running into an issue with my settings not being updated after a save every time. Here's an example. I made the change that is circled and saved. Then ran the gcode and I get the error in the second figure.

I tried saving several times with no improvement. Then I restarted the controller and I was back to my original code (shown in red type & circled below). I then edited the settings again and saved... and the code was executed correctly.
Does this mean I need to reboot prior to making changes or is there a way to refresh things without a controller reboot.

I've noticed that it happens sometimes when running jobs also. When a z height is set incorrectly or a feed speed is too high, I go into Aspire and make the changes, save, upload to the controller and run it again and find that the changes have not been made. I've started adding version numbers to each file I upload just to be able to verify I am running the correct version of the modified code.
Attachments
Item2.jpg
Item 2
Itme1.jpg
Item 1
R.T.Kracht
Huffman, TX

Post Reply