Buildbotics Forum

I just downloaded V1.0.0 and it is a hot mess for me, I can run a program as long as it's off a stick drive that I put in the back WIFI does not work now.
Permenant message warning COMM SRC/modbus.c:257 repeat is counting up, message:0 OK: modbus: unexpected response to read
no Gcode at all when running program, Gcode editor does not show anything when a program is loaded

I would like to reload but no wifi can you provide me with a fresh install of the software so that I can do a manual upload.

I found a V1.1.0 file on one of the boards, reloaded and everything that I have worked with seems to be working correctly except I still have the error Permanent message warning COMM SRC/modbus.c:257 repeat is counting up, message:0 OK: modbus: unexpected response to read

Here are a few questions:

• Do you have a VFD?

• If so, what type?

• What type is assigned on Settings->Tool page?

• Are errors counting up in tool page?

I do not use the VFD function, I adjust it using the rheostat.

if that is the error that I am getting we are golden.