external emergency stop paddle wiring
Forum rules
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
external emergency stop paddle wiring
I am trying to wire in an emergency stop paddle between pin 23 estop on the breakout box and Pin 25 GND, and when I close the circuit nothing happens. What am I doing wrong.
Re: external emergency stop paddle wiring
Check the I/O Settings page to ensure that it is assigned to pin 23.
Re: external emergency stop paddle wiring
I checked the manual, in fact all manuals say that Pin 23 is Estop. I verified that the pin that I am using for ground is in fact case ground Pin 19. when I ground it out I get nothing, do you have any solutions that might fix it? I am using Software update 1.0.3 with a box that is about 2 years old
If I am unable to make the software e stop work I will wire it in as a powered hard emergency stop.
If I am unable to make the software e stop work I will wire it in as a powered hard emergency stop.
Re: external emergency stop paddle wiring
Here is a link to the latest manual that describes the programmable I/O on the Buildbotics Controller.
https://buildbotics.com/manual-v1-0-2/#iotab
You must be using the latest software (v1.0.2 or v1.0.3). Otherwise the estop is fixed on pin 23.
https://buildbotics.com/manual-v1-0-2/#iotab
You must be using the latest software (v1.0.2 or v1.0.3). Otherwise the estop is fixed on pin 23.