Recurrent Controller Problems
Posted: Mon Feb 06, 2023 6:01 am
I keep getting recurring errors that occur in the middle of cuts. I lose home and offset positions each time it happens.
I never had any of these errors before the last firmware update but now it is very common. I'm using the Fusion 360 post but I don't think it is related to gcode.
How can I diagnose and fix this? Is there a way to reset the controller?
I have attached images of the errors I'm getting.
Thanks
I never had any of these errors before the last firmware update but now it is very common. I'm using the Fusion 360 post but I don't think it is related to gcode.
How can I diagnose and fix this? Is there a way to reset the controller?
I have attached images of the errors I'm getting.
Thanks