Buildbotics Forum

I am having problems with an intermittent alarm that pops up. Command not processed is the alarm any advice or insight on this alarm would be helpful. I have tried to add pictures but this format says the file is to big hopefully I have described it well enough for some help in this matter

Can you send the gcode program that you are running when the error occurs? Also, what version of software is your controller running?

The version is V0.4.14 and I will have to try to send g code tomorrow when I get home from work. Thanks

Ok so I have not had any luck getting the g-code to be able to send for some analysis but have noticed a new development.... I was able to run a few other files today and after the machine had ran for a few minutes before it alarmed with the same message , Command not processed, so it seems not to be a file problem as it has done it on a few different files now. also I ran it manually with the handheld controller and ended up getting the same, command not processed. i will continue to try to get another usb cable, as i belive mine is bad, to interface with the controller and get information from the controller itself and send. i hope the additional information helps some. i am trying to add some pictures but not having any luck with sending any, is there an email or something that i can send these to and try to get some better information to you??

I recommend upgrading your controller to V1.0.3. If you need help with this, feel free to call me at (925)577-9940.

Doug

Thanks for the insight, I will try this as soon as I get a chance and let you know how it goes. Thanks again!!