Page 1 of 1
Speed and Feeds override during Job
Posted: Sun Apr 26, 2020 11:54 am
by BiuTse
Would be nice to change speed during a job.
Re: Speed and Feeds override during Job
Posted: Sun Apr 26, 2020 5:14 pm
by Doug
Adjusting feed rate on the fly is pretty difficult. But, adjusting spindle speed is not too difficult. What would you think of being able to adjust spindle speed but not feed rate as an interim feature?
Re: Speed and Feeds override during Job
Posted: Wed Apr 29, 2020 11:21 pm
by BiuTse
Hmm Spindle speed is not a problem now because I still have to use a separate powersupply for the PWM for my spindle. Still didn't get the PCB we spoke about from China.
But yes this would be already a step in the right direction
Re: Speed and Feeds override during Job
Posted: Thu Apr 30, 2020 2:38 pm
by Doug
Thanks for the input. Maybe we can get the ability to adjust spindle speed on the fly added soon.
Re: Speed and Feeds override during Job
Posted: Thu Jan 20, 2022 12:33 pm
by Bob916
I would be more interested on having more control over the feed rate on the fly. Is there anything in the works toward this?
Re: Speed and Feeds override during Job
Posted: Sun Feb 20, 2022 7:02 am
by donramsey
Changing the feed rate during a run would be a great addition.
Re: Speed and Feeds override during Job
Posted: Fri Jun 02, 2023 10:22 am
by DainBramage1
Doug wrote: ↑Sun Apr 26, 2020 5:14 pm
Adjusting feed rate on the fly is pretty difficult. But, adjusting spindle speed is not too difficult. What would you think of being able to adjust spindle speed but not feed rate as an interim feature?
Is the inability to adjust feedrate on the fly a hardware challenge or software? Would it be possible to make it happen by using GSender or some other gcode sender? I haven't had my Onefinity Journeyman long, but I already miss that functionality!! Thank you.
-- Brad
Re: Speed and Feeds override during Job
Posted: Sun Jun 04, 2023 10:31 am
by Doug
It is a soft issue. It is not feasible to integrate GSender.