Hi,
the controller manual includes the following sequence:
"The L1 and L2 outputs can be software controlled through G-Code commands or they can be controlled through hardware by applying logic signals to the “Load 1” o r “Load 2” pins on the DB25 I/O connector."
How can i control L1/L2 through G-Code - what commands?
Greetings
Martin
L1/L2 controll through G-Code
Forum rules
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
Re: L1/L2 controll through G-Code
M7 turns on L1,
M8 turns on L2,
M9 turns off both L1 and L2
Hope this helps,
Doug
M8 turns on L2,
M9 turns off both L1 and L2
Hope this helps,
Doug
Re: L1/L2 controll through G-Code
yes
thanks and greetings
Martin
thanks and greetings
Martin