0.4.13 released

Post by **Doug** » Thu Feb 27, 2020 6:25 pm

Software version 0.4.13 is available. It provides the following improvements:
* The Buildbotics Controller can now control OMRON MX2 Variable Frequency Drives. It has been added to the tool-type pull-down menu on the "Tool" page.
* Error handling during WiFi configuration has been improved.
* Video performance has been improved. You will now experience lower latency and higher frame rates when streaming video from your Buildbotics Controller.
* Up to four clients can now view the video stream from the Buildbotics Controller simultaneously.
* Axis bounds GCode variables #<_x_min>, #<_x_max>, etc. are now accessible from GCode programs and from the program-start, tool-change, and program-end text boxes on the "Settings" page.
* You can now configure junction acceleration from the "Settings" page. This allows you to specify the maximum acceleration allowed when rounding corners.
* A problem existed that prevented users from doing manual software "Uploads" from OSX computers. This has been fixed.
* Cameras that do not support MJPEG format video are now ignored.