Have a controller running 1.0.3. Picked up an Elo ET2201 touchscreen. Plugged in and is completely functional right away, except the horizontal calibration is off on the touchscreen. In the center, it's on. But as you touch further outward, it gets more and more off. When you touch the outer LH/RH edge of the screen, it's about an inch off.
I am trying to figure out some calibration routine. Any suggestions?
Touchscreen calibration
Forum rules
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
No profanity, no gambling, no illegal activity, so sexual or pornographic material.
Posts not related to the Buildbotic CNC Controller are likely to be moved or deleted.
Re: Touchscreen calibration
Have you tried adjusting the resolution of the monitor? My ASUS VT168H runs at 1366 x 768 resolution. You can also try adjusting the sweep frequency. Available options are usually 50hz and 60hz.
Doug
Doug