Speed and Feeds override during Job

Post any suggestions that you have for new features and enhancements for the Buildbotics Controller here.
Post Reply
BiuTse
Posts: 22
Joined: Tue Mar 03, 2020 8:57 pm

Speed and Feeds override during Job

Post by BiuTse » Sun Apr 26, 2020 11:54 am

Would be nice to change speed during a job.

User avatar
Doug
Posts: 362
Joined: Fri Feb 02, 2018 4:56 pm

Re: Speed and Feeds override during Job

Post by Doug » Sun Apr 26, 2020 5:14 pm

Adjusting feed rate on the fly is pretty difficult. But, adjusting spindle speed is not too difficult. What would you think of being able to adjust spindle speed but not feed rate as an interim feature?

BiuTse
Posts: 22
Joined: Tue Mar 03, 2020 8:57 pm

Re: Speed and Feeds override during Job

Post by BiuTse » Wed Apr 29, 2020 11:21 pm

Hmm Spindle speed is not a problem now because I still have to use a separate powersupply for the PWM for my spindle. Still didn't get the PCB we spoke about from China.

But yes this would be already a step in the right direction

User avatar
Doug
Posts: 362
Joined: Fri Feb 02, 2018 4:56 pm

Re: Speed and Feeds override during Job

Post by Doug » Thu Apr 30, 2020 2:38 pm

Thanks for the input. Maybe we can get the ability to adjust spindle speed on the fly added soon.

Bob916
Posts: 1
Joined: Sat Jan 08, 2022 7:03 am

Re: Speed and Feeds override during Job

Post by Bob916 » Thu Jan 20, 2022 12:33 pm

I would be more interested on having more control over the feed rate on the fly. Is there anything in the works toward this?

donramsey
Posts: 3
Joined: Thu Feb 17, 2022 8:53 am

Re: Speed and Feeds override during Job

Post by donramsey » Sun Feb 20, 2022 7:02 am

Changing the feed rate during a run would be a great addition.

DainBramage1
Posts: 1
Joined: Wed May 31, 2023 2:40 am

Re: Speed and Feeds override during Job

Post by DainBramage1 » Fri Jun 02, 2023 10:22 am

Doug wrote:
Sun Apr 26, 2020 5:14 pm
Adjusting feed rate on the fly is pretty difficult. But, adjusting spindle speed is not too difficult. What would you think of being able to adjust spindle speed but not feed rate as an interim feature?
Is the inability to adjust feedrate on the fly a hardware challenge or software? Would it be possible to make it happen by using GSender or some other gcode sender? I haven't had my Onefinity Journeyman long, but I already miss that functionality!! Thank you.

-- Brad

User avatar
Doug
Posts: 362
Joined: Fri Feb 02, 2018 4:56 pm

Re: Speed and Feeds override during Job

Post by Doug » Sun Jun 04, 2023 10:31 am

It is a soft issue. It is not feasible to integrate GSender.

Post Reply